Fisher & Paykel DS601IV2 Dishwasher User Manual


 
- 13 -
4.3 Diagnostic Modes
4.3.1 Temperature Display Mode
During a wash cycle, the current water temperature can be displayed on the LCD
instead of the time remaining. To enter temperature display mode, start a wash cycle
as normal. Initiate a keylock by pushing and holding the Keylock button for 4
seconds.
Once in keylock mode push and hold Start/Pause for 8 seconds to enter temperature
display mode. The temperature is now displayed and the MIN symbol is switched off.
Keylock mode can now be exited.
To cancel temperature display mode, either repeat the above procedure or enter power
off mode by pressing Power. Temperature display mode is automatically cancelled at
the end of a wash program (even in CC mode).
4.3.2 Rinse Aid / Tub-Open Beep Water Pressure Setup Mode
To enter this setup mode, hold the Programme and Eco touch switches
simultaneously for 5 seconds. Once the setup mode is entered a beep is emitted and
the LCD is red with HPdisplayed.
Push Power at any time to exit this setup mode.
4.3.3 Rinse Aid Setup
The current rinse aid setting is shown using orange LEDs on the touch switch panel.
The amount of rinse aid dispensed into a rinse cycle can be varied to suit the level of
hardness of the local water supply. It is adjusted for 1 - 5 dispenser levels
(1 = approx 1ml of rinse aid , 5 = approx. 5mls of rinse aid).
Push Programme to advance the rinse aid setting. Once the desired setting is
achieved, push Power to exit. The rinse aid index is stored in EE memory, so even
with the power removed, the rinse aid level is retained.
4.3.4 Tub-Open Beep Setup
The beep sequence that occurs when the tub is opened can be turned on or off using
the Keylock button. If the Smily Face on the LCD is On then the beep sequence will
occur when the tub is Opened. If the Smiley face is Off then no beeps will occur when
the tub is Opened. Push Power to exit when the desired setting has been selected.
The Integrated Model will sound a single beep when turning this option off, while the
actual beep sequence is sounded when turning this option on. The DishDrawer will
default to 'beeps on' if the mains power is removed.