Filter
Top Products
11
Installation instructions
5. What to do if your product is unstable
E
Gently push the refrigerator back until the rear rollers
contact the floor.
Measure the gap under the front foot, which has come
off the floor.
Obtain some solid packing material (hardwood,
plastic,etc) which fits firmly into the gap under the foot.
Note: do not use metallic materials that may corrode,
stain and/or damage floor coverings.
F
Wind both front feet up and roll the product out
ofposition.
Place the packing material in the location diagonally
opposite the front roller that lifts off the floor.
Make sure the packing material stays in place when the
product is pushed back into position.
Ideally, the packing material is large enough to rest
against the back wall so as to prevent it moving when
the cabinet is pushed into position.
Wall behind refrigerator
For example: if this foot lifts off
the floor when pushing gently on
the top front of the refrigerator
Packing material goes under rear roller
diagonally opposite front foot that lifts
Fig.6 Stabilising your refrigerator
G
Roll the refrigerator back into position and adjust front feet as per step
D
. (Check alignment and
door closing action are satisfactory).
Make small adjustments to front feet where necessary.
This foot lifts off the floor when
top front is gently pushed back
Example only
Unlevel floor
Fig.5 Unstable refrigerator