Filter
Top Products
12
Installation instructions
Check that the product is stable (all 4 feet are on the floor). If not return to step
E
and repeat
steps
F
and
G
.
Before placing food in the fresh food or freezer compartments
Remove all packaging. Ensure that all transit clips are removed from the refrigerator. These are
small rubber stops located at the back of the shelves.
Allow the refrigerator or freezer to run empty for 2 – 3 hours so each compartment can cool to
the appropriate temperature.
Clean the inside of the appliance with warm water and a little liquid detergent to remove
manufacturing and transportation dust.
The appliance may have an odour on its initial operation, but this will go when the refrigerator
and freezer have cooled sufficiently.
Energy efficiency
For the most energy efficient use of your appliance:
Ensure your refrigerator or freezer has adequate ventilation as recommended in the
installationinstructions.
Do not cover your appliance with any material that will prevent air from flowing around the
cabinet sides.
Allow good clearances in front of air ducts within the cabinet for maximum cold air distribution.
Cool hot foods down before placing them in the appliance.
Do not overfill the compartment(s).
Keep door openings to a minimum.
Select a temperature setting that isn’t too cold.
Check your door seals for leaks.