Filter
Top Products
7
Installation instructions
11
Attach double sided foam to the back of the water filter head as shown in
Diagram 5. Write the date to be replaced on the filter (date installed + 6
months). Remove double sided foam backing and attach filter to the desired
position as located in step 10 (refer to previous page).
12
Run the ¼” (6 mm) tubing to back of the refrigerator ensuring there is enough
tubing to pull out the refrigerator for service.
13
Remove compressor compartment cover by removing screw at the top of
each side of the cover as shown in Diagram 6. Lift and tilt the compressor
compartment cover to remove as shown in Diagram 7.
14
Connect tubing into the water (solenoid) valve located on the right hand side of
the unit (compressor) compartment as shown in Diagram 8. Beware of hot pipes.
15
Pull gently on tubing to ensure it is locked in as shown in Diagram 9.
16
Place compressor compartment cover back into position, run the ¼” (6 mm)
tubing through the space provided at the top right hand side of the
compressor compartment cover in an upward direction and rescrew the
compressor compartment cover. As shown in Diagram 10.
17
The completed installation should look like Diagram 12 on page 8.
18
Turn isolating faucet on and check that all connections are dry and free of drips. If not, please
alert the plumber.
19
Coil water line tubing behind the refrigerator. Push your refrigerator into place being careful not
to kink or squash the water line running into the water (solenoid) valve.
20
Read pages 9 – 14 carefully, and then turn refrigerator on.
21
The first time you require water out of the dispenser, there will be a delay while the water
reservoir fills up. As this is happening, the symbol will flash. Once the reservoir is full, this
symbol will stop flashing.
Diagram 5
Fig.7 Double sided
foam attachment
Fig.8 Waterline connection to refrigerator
Diagram 6 Diagram 8 Diagram 9
Diagram 7 Diagram 10
INSTRUCTIONS
EN