Filter
Top Products
9
Installation instructions (all models)
4. Installation
It is important that all four corners of the refrigerator base are supported firmly on the floor to
eliminate any cabinet movement.
Installing the appliance on a soft or uneven or unlevel floor may result in twisting of the cabinet
and poor sealing of the doors. If the doors do not seal properly, warm air will enter the food
storage areas causing the temperature to increase, resulting in food spoilage and food loss.
Your Fisher & Paykel Active Smart™ refrigerator is fitted with front
and rear rollers, designed for moving the product in the forwards
and backwards direction. Avoid moving the product in a sideways
direction as this may damage the rollers or the floor covering/surface.
A
Your refrigerator will arrive with the front feet wound up making
moving the product into its final location a simple task.
B
Roll the refrigerator into its final position making sure there is the
correct air gap between the product and surrounding cabinetry. See
minimum clearance in cabinetry dimensions table (refer to page 7).
If required raise the front of the appliance (by turning the
adjustable feet clockwise) until it is stable and the doors move
towards the closed position on their own, when open.
The front levelling foot on the hinge side should take the
majority of the weight of the cabinet and the cabinet should
be stable, ie the cabinet should not rock or wobble.
(Model RF610A only)
C
Adjust the front feet down until the refrigerator is leaning backward
with the front approximately 10 mm higher than the back. This will
ensure a good door closing action. (Refer to Fig.2).
D
Aligning your refrigerator with cabinetry.
Align the sides of the refrigerator with the cabinetry by adjusting
the hinge side front foot.
Adjust the handle side foot until it touches the floor and takes a
small amount of weight.
Once the refrigerator is in place and aligned with cupboards/alcove
push gently on the front top and check if the product is rocking or stable.
5. Levelling of refrigerator door (model RF610A only)
For uneven surfaces, front feet can be used to align the 2 doors.
If left hand door is too low, then unscrew the left hand foot to lift
up the cabinet until the two doors top edges are aligned.
If right hand door is higher, then adjust the right hand foot in the
same way.
Fig.3 Uneven door alignment
Raise the
front of the
refrigerator
Lower the
front of the
refrigerator
Fig.2 Refrigerator feet
Fig.4 Even door alignment