BEFORE YOU START
PAGE 2 OF 8
New Zealand
Australia
INSTALLATION INFORMATION
TITAN BUILT - IN OVENS
OS301 / OD301 SERIES
It is the customers responsibility to ensure that the product is electrically
connected by a qualified electrical installer and conforms with all local electrical codes.
Failure to install the product correctly could invalidate any warranty or liability claims and lead to prosecution.
Make sure that the oven is located away from any strong and/or hot drafts of air.
The cabinet opening dimensions specified are the absolute minimum. These dimensions allow a clearance of up to 6mm.
The product must be electrically grounded.
We recommend that the outlet for the electrical supply cable is located in the right rear corner of the cabinet cavity.
This allows the electrical supply cable to sit inside the rear chamfered corner of the oven and prevents it being jammed
between the cabinet wall and the rear of the oven.
The oven support surface should be flat, level and be able to support a weight of
at least (190 Kg) for a double oven and (108 Kg) for single oven models.
You will need a No.2 Phillips screwdriver to complete the installation of the oven
into the cabinet. There should be 4 suitable wood screws with this installation kit
(Part number 556075) and 4 spacers (Part number 545455).
Allow at least 1.5m free length of connection cable within the cavity for ease of
installation and service of the oven.
Ensure a suitable disconnection switch is incorporated in the permanent wiring,
mounted and positioned to comply with the local wiring rules and regulations.
PAGE 1 OF 8
P/N 545854C
DATE OF ISSUE
11 / 2003
IMPORTANT - SAVE FOR THE OVEN INSTALLER’S USE
Outlet for
electrical supply