Filter
Top Products
7
Handle Removal
Handles are installed at the factory.
Materials Needed:
• 4 mm (
5
⁄32” ) Allen wrench
To Remove:
• Remove cap-screw from handle mounting post
using 4 mm (
5
⁄32” ) Allen wrench.
• Repeat the procedure on all posts to remove the
handle.
To Replace:
• Align handle with the mounting posts.
• Fully tighten all cap-screws to secure handle
in place.
INSTALLATION
6. Pull on tubing to confirm connection is secure.
Connect tubing to frame
with water tubing clamp
(C) and turn on water
supply. Check for leaks
and correct if necessary.
Continue to observe the
water supply connection
for two to three hours
prior to moving the
refrigerator to its
permanent location.
7 . Monitor water connection for 24 hours.
Correct leaks, if necessary.
C