Filter
Top Products
35
Replacing light bulbs
WARNING!
Electric Shock Hazard
Disconnect power to refrigerator before replacing light bulb. After replacing
light bulb, reconnect power.
Failure to do so can result in death or injury to persons.
Caution!
To avoid personal injury or property damage, observe the following:
Before handling, allow light bulb to cool once refrigerator has been
turned off.
Wear gloves when replacing light bulb.
Upper fresh food section (all models)
The upper fresh food light bulbs are located behind the front
panel. Reach behind the panel to remove the bulbs.
Lower fresh food section and upper freezer section
(RX616 model)
1
Push up on bottom tabs of light cover. Rotate cover up and
release tabs.
2
Remove light bulb. Replace bulb with an appliance bulb
no greater than 40 watts.
3
Insert top tabs of light cover into liner slots and snap bottom
tabs into liner slots.
Upper freezer section (RX693 / RX594 models)
1
Remove ice bin by lifting front of bin and pulling out.
2
Remove light shield by pressing the upper right side of the
shield and rotating downward.
3
Remove light bulb. Replace with an appliance bulb no greater
than 40 watts.
4
Rotate the shield upward, press in slightly and snap into place.
5
Replace ice bin by sliding in until bin locks into place.
Lower freezer section (all models)
1
Pinch both sides of light cover to remove.
2
Remove light bulb. Replace with appliance bulb no greater than 40 watts.
3
Pinch both sides of the light cover to snap into place.
Ice and water dispenser
On RX693 / RX594 models a service call is required if light bulb fails (see page 46).
Care and cleaning
Fig.25 Lights in upper freezer
section (RX693 / RX594 models)
Fig.24 Light in lower fresh
food section (RX616 model)