Filter
Top Products
7
Installation instructions
3
Close doors.
4
Remove top hinge covers by removing
Phillips screws.
5
Unscrew 8 mm hex head screws from
top hinges.
6
Detach main wire connector harness.
Do not remove screw connecting green
ground wire.
To detach main wire harness, use a flat
blade tool or fingernail to press junction
point between two connectors to release.
7
Remove top hinges along with doors.
8
Remove bottom hinges with a 9.5 mm
hex head driver.
Replacing the doors
To replace the doors, follow the steps in
door and hinge removal in reverse order.
Important!
If water line tube end is damaged, cut off
16 mm before reconnecting.
RX616 model
1
Unplug power cord from power source.
2
Remove toe grille (see page 8).
3
Unscrew screws from top hinges.
4
Remove top hinges along with doors.
5
Remove bottom hinges with a 9.5 mm
hex head driver.
Replacing the doors
To replace the doors, follow the steps in
door and hinge removal in reverse order.
Step 4
Step 6
Step 7
Step 8
Fig.4 Door and hinge removal (RX616 model)
Step 5Steps 3 and 4
Fig.3 Door and hinge removal
(RX693 / RX594 models)