Filter
Top Products
- 7 -
3. Slide the waste pipe flange on to the waste pipe.
4. Attach the rubber gasket to the waste pipe so that the thin
lip is facing the disposer. (ILLUSTRATION #14)
5. Insert the non-notched end of the waste pipe flange into the
slot below the waste outlet on the waste disposer.
(ILLUSTRATION #15)
6. Use the screw to tighten the waste pipe to the disposer.
7. Rotate the disposer so that the waste pipe lines up with the
drain trap. (ILLUSTRATION #16).
8. Once the waste pipe is lined up use a pipe wrench to
tighten the slip nut on the drain trap. ILLUSTRATION #17).
9. If fitted to a double sink, the use of separate traps for the
disposer and the sink are recommended.
10. Make sure that the hinged clamp is locked firmly in place.
ILLUSTRATION #14
ILLUSTRATION #15
ILLUSTRATION #16
ILLUSTRATION #17