Filter
Top Products
17
How to Make a Bead
To dispense a continuous bead of fluid instead of
a single dot, follow these steps.
Switch the AUTO/MANUAL switch to
MANUAL.
Set the shot size to the lowest setting.
For best results, set the dispense rate to slow,
to minimize backpressure in the syringe.
As a beginning point, set drawback to 5 steps
Keep delay set to zero, then adjust as needed
to eliminate any post dispense ooze.
• Press and hold the foot pedal until the
required amount is dispensed.
5
4
3
2
1
Retract Manual Hand
Extend Auto Foot
1
.00261 cc
.00261-12.2335
.065 cc/sec
.065 - 1.567
5 STEPS
0 - 500
0 seconds
.00 - 10.00
2
3
4
5