Filter
Top Products
EN
1
12
Charcoal filter (recycling version)
• This filter cannot be washed or regenerated. It must be replaced when the EF appears on the
display or at least once every 4 months.
Activation of the alarm signal
• In the recycling version hoods the filter saturation alarm must be activated during the instal-
lation or later.
• Switch off the hood and the lights.
• Disconnect the hood from the mains supply.
• When restoring the connection press and hold B-key.
• When releasing the key two rotating rectangles appear on the display.
• Within 3 seconds press the B-key until a flashing confirmation appears on the dispaly:
• 2 flashes with EF - charcoal filter saturation alarm ACTIVATED
• 1 flash with EF - charcoal filter saturation alarm DEACTIVATED.
REPLACING THE CHARCOAL FILTER
Reset of the alarm signal
• Switch off the hood and the lighting. If the 24h-function has
been activated this has to be deactivated.
• Press the E-key until the display is unlit.
Replacing of the filter
• Open the comfort panels by pulling them downwards.
• Remove the metal grease filters.
• Remove the saturated charcoal filter by releasing the fixing
hooks.
• Fit the new filter and fasten it in its correct position.
• Put the metal grease filters in their seats.
• Close the comfort panels.
CHANGING THE SOUNDPROOFING ELEMENT
• Open the Comfort panels by pulling them.
• Remove the Metal grease filters.
• Remove the Activated charcoal filter, using the hooks pro-
vided.
• Pull out the Soundproofing Element from below, pressing the
side fins to disconnect it from the slot in the Hood Canopy.
• Clean it with a damp cloth and replace it, first making sure that
it is completely dry.
• Replace the Activated charcoal filters.
• Replace the Metal grease filters.
• Close the Comfort panels.