Filter
Top Products
EN
8
8
ELECTRICAL CONNECTION
• Connect the hood to the mains through a two-pole switch hav-
ing a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance) being
sure that the connector of the feeding cable is correctly inserted
in the socket placed on the side of the fan.
Fitting the Chimney
Upper chimney
• Open the two side pieces out slightly, hook them up behind the
brackets 7.2.1 and bring them back together again until they
are in contact.
N.B. The bottom bracket may be omitted.
• Fix the sides of the Brackets using 4 Screws 12c (2.9 x 9.5),
provided.
• Make sure that the Connector outlet is in correspondence with
the Chimney openings.
Lower chimney
• Open out the two Chimney side flaps, hook them up between
the upper chimney and the wall and then close them up again
until they touch.
• Fix the lower part to the Hood canopy at the sides, using 2
screws 12c (2.9 x 9.5) provided.
• Fit the Comfort Panel on the body using the fixing pins
provided, and hook up the safety catch.
7.2.1
2.1
2.2
2
15
1
30
12c
12c
12c
11
22