Filter
Top Products
19
5. When you want to clean the machine, turn off the power switch first, then turn it on again.
Press the Clean button within 3 minutes and the ice maker will start the cleaning mode, with
harvest and ice-making indicators blinking. After 30 minutes, the cleaning mode stops and the
harvest indicator and ice-making indicators are on steady. If you want to restart the
ice-making process after cleaning, turn off the power switch first, then turn on the power
switch again and the machine will automatically go into the ice-making process.
6. If you want to interrupt the cleaning mode before it is finished, do not press the Clean button
again. Instead, turn the power switch off. This stops the cleaning cycle.
7. If the machine is on but only the power indicator light is lit, this may indicate that not enough
water is reaching the system, that the water pump is not functioning, or some similar problem.
First check the level in the water tank, then examine the water pump, etc.
8. If the unit is connected to the power supply but no visual indicator lights up when the power
switch is turned on, the fuse in the control panel box may need to be replaced.
Descriptions of LEDs and buttons:
1. Bin Full (white) LED: Bin Full indicator light
When this LED is on, this indicates that the ice level in the bin is high enough to hold the
water curtain open, the microswitch is open, or there is something obstructing the closing of
the water curtain. The unit will stop working. When ice cubes are removed from the ice
storage bin, clearing the ice-full probe, the white LED will flash for 3 minutes. Then the unit
will restart and return to the ice-making mode.
2. Ice Making (Green) LED: Ice Making indicator light
When this LED is on, the unit is in the ice-making mode.
3. Ice Harvest (Yellow) LED: Ice Harvest indicator light
When this LED is on, the unit is working in the ice harvest mode controlled by microswitch.
4. I. S. adjust: Ice bridge adjustment
For service only. Adjustment of this screw by unqualified persons can damage the machine’s
controls.
5. Power switch
This is the main switch. When it is turned on, the unit starts working after 3 minutes. The
power indicator LED is on.
6. Clean button
If you press the Clean button within three minutes after the power has been turned on, the ice
maker will enter the cleaning mode. If you press the Clean button and hold it for more than six
seconds, the machine will enter the draining mode. The green and yellow LEDs will be
blinking together.
IMPORTANT:
· Avoid letting water contact the control box.