19
Changing Cooktop and/
or Oven Lights
(some models)
To Change the Cooktop Light (some models)
1. Turn power off at the main source or unplug the range.
2. Remove Phillips® Head screws (2) that secure the light cover and then lift the
light cover off.
3. Remove bulb by rolling back and up. Install the new bulb by sliding down and
rolling forward into place.
4. Re-install light cover and secure with Phillips® Head screws (2).
To Change the Oven Light (some models)
On some models, the oven light automatically turns on when the door is
opened. Some models have a switch located on the control panel to turn on the
light. The oven light is located at the rear of the oven and is covered with a glass
shield held by a wire holder. The glass shield must be in place whenever the
oven is in use.
To replace the oven light:
1. Turn electrical power off at the main source or unplug the range.
2. Press wire holder to one side to release the glass shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder into place.
5. Turn power back on again at the main source (or plug the range back in).
6. The clock(if equipped) will then need to be reset. To reset, see Setting the
Clock and Minute Timer in this Owner's Guide.
Be sure the range is
unplugged and all parts are COOL before
replacing the surface or oven lights.
Wear a leather-faced glove for
protection against possible broken
glass.
To Clean the Spice Rack (some models)
To mount the rack to the range refer to your Installation Instructions.
To Remove Spice Rack :
1. Remove all the spices from the spice rack.
2. Lift up on the bottom of the spice rack to remove it from the support posts.
To Clean Spice Rack:
1. Using a mild dish detergent, clean the spice rack. Cover stubborn spots with
an ammonia-soaked paper towel for 30 to 40 minutes. Cleaners made
especially for stainless steel, chrome or copper are also recommended.
2. Rinse with clean water and a cloth.
3. Rinse off all cleaners and wipe dry before operating the range. Bluish stains
may result due to heat combining with the cleaning material; these stains
cannot be removed.
To Reinstall the Spice Rack:
1. Place the spice rack on top of the support posts. Make sure the top lip hooks
over the top of the support posts and the side flanges are around the side
of the support posts as shown in the diagram in Figure 1.
Figure 1
General Cleaning
(continued)