Frigidaire 318200964 Oven User Manual


  Open as PDF
of 24
 
10
To Set or Change the Temperature for
Baking
The oven can be programmed to bake at any
temperature from 170°F to 500°F (76°C to 260°C).
To Set the Controls for Baking:
1. Press BAKE pad. "— — —°" appears in the display.
2. Within5seconds,presstheUP or DOWN ARROW
pad. The display will show "350°F." By pressing
and holding the UP or DOWN ARROWpad,the
temperature can then be adjusted in 5°F increments.
3. When the UP or DOWN ARROWpadisreleased,
the oven will begin heating to the selected
temperature. When the displayed temperature
reachesthedesiredbakingtemperature,thecontrol
will beep once (1 time).
4. Tocancelthebakingfunction,pressCLEAR OFF
pad.
To Change the Oven Temperature after Baking has
Started:
1. Press BAKE pad and make sure the bake
temperature is displayed.
2. Press the UP or DOWN ARROW pad to increase or
decrease the set temperature.
To Broil
1. Arrange oven rack while oven is still cool.
2. Press BROIL pad.
3. Press and hold the UP or DOWN ARROW pad until
the desired broil setting level appears in the display.
Press the UP ARROW pad for HI broil or the DOWN
ARROW pad for LO broil. Most foods can be broiled
at the HI broil setting. Select the LO broil setting to
avoid excess browning or drying of foods that should
be broiled to the well-done stage.
4. Placetheinsertonthebroilerpan,thenplacethe
food on the insert. DO NOT use the broiler pan
without the insert or cover the insert with aluminum
foil. The exposed grease could ignite.
5. Place the pan on the oven rack. Close the oven
door when broiling.
6. Broilononesideuntilfoodisbrowned;turnandcook
on the second side. Note: Always pull the rack out to
the stop position before turning or removing food.
7. Whenbroilingisnished,pressCLEAR OFF pad.
SETTING OVEN CONTROLS - MODEL A
CAUTION
Should an oven re occur, close the oven door
and turn off the oven. If the re continues, use a
re extinguisher. DO NOT put water or our on
the re. Flour may be explosive.
Adjusting Your Oven Temperature
Your new oven has been factory calibrated and tested
toensureanaccuratebakingtemperature.Fortherst
fewuses,followyourrecipetimesandtemperature
recommendations carefully. If you feel your oven is too
hotortoocoolfromyourbakingexperience,theoven
temperature may be adjusted to your liking.
NOTE
DO NOT adjust your oven temperature based on oven
thermometers,suchasthosefoundingrocerystores,
they may not be accurate.
To Adjust the Oven Temperature (do not use Bake
or Broil while adjusting the oven temperature):
Note: Your oven control was factory set in the
(Fahrenheit) °F Temperature Display Mode. To change for
(Celsius)°C,seepage15.
1. Press & hold the BAKE key pad and release after the
display shows the factory temperature setting of 00.
Note: If the oven temperature has been previously
adjustedfromthefactorysetting,thecurrent
temperature adjusted value will appear in the display
instead.
2. You may increase the oven temperature in 5°F (1°C)
increments with each press of the UP ARROW pad
to a maximum oven adjustment of +35°F (+18°C).
You may also adjust the oven temperature downward
in 5°F (1°C) increments with each press of the
DOWN ARROW pad (total range of -35°F to +35°F
(-18°C to +18°C).
3. Ifyoudonotwanttokeepthedisplayadjustment,
press the CLEAR OFF pad before the oven control
beeps. This will cancel the temperature adjustment
procedure. To start this procedure over again begin
withstep1aboveOR;
4. Ifyouwanttokeeptheadjustment,waituntilthe
oven control beeps once.
5. The oven temperature adjustment has be accepted
by the oven control and the display will return to the
time of day.
FAILURE MODES
All failure modes give a visual and audible alarm. When
displayshowsF10(temperaturerunaway),F30-F31
(ovensensorcircuitfault)oranyotherFerrorcodes,the
electronic oven control has detected a fault condition.
Note that code and push the CLEAR OFF pad to clean
the display and stop the beeping. Reprogram the oven.
Iffaultrecurs,pushCLEAROFFpad,disconnectthe
appliance to prevent damage and contact an authorized
servicer.
 previous next