Frigidaire 318200964 Oven User Manual


  Open as PDF
of 24
 
16
SETTING OVEN CONTROLS - MODEL B
CAUTION
Use care when opening the oven door after self-clean-
ing cycle. Stand to the side of the oven when opening
the door to allow hot air or steam to escape.
DO NOT force the oven door open. This can damage
the automatic door locking system. Use caution when
opening the door after the self-cleaning cycle is com-
pleted. The oven may still be VERY HOT.
Self-cleaning
To Start the Self-Clean Cycle
*Werecommenda2hourself-cleancycleforlightsoils,
and a 3 hour cycle for average to heavy soils (to assure
satisfactory results).
To Set the Controls for a Self-Clean Cycle:
1. Be sure the clock shows the correct time of day.
2. Push the CLEAN pad. "- - -" appears in the display.
3. Push the UP ARROW pad until "3:00" appears in the
displayfora3hourcycle,orpushtheDOWNARROW
pad until "2:00" appears in the display for a 2 hour
cycle.
4. AssoonastheUPorDOWNARROWpadisreleased,
"CLn" appears in the display.
5. Assoonasthecontrolsareset,themotordriven
lock will begin to close automatically and the "Door
Locked"indicatorlightwillash.DONOTopenthe
doorwhilethelightisashing(ittakesabout15
seconds for the lock to close).
6. The "Door Locked" light will glow until the cleaning
cycleiscompletedorcancelled,andtheoven
temperature has cooled.
When the Self-Clean Cycle is Completed:
1. The time of day will appear in the display window
and the "Door Locked" light will continue to glow.
2. Once the oven has cooled down for about 1 hour and
the"DoorLocked"lighthasgoneout,theovendoor
can be opened.
Stopping or Interrupting a Self-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-
cleaning cycle due to excessive smoke or re:
1. Push the CLEAR OFF pad.
2. Once the oven has cooled down for about 1 hour and
the"DoorLocked"lighthasgoneout,theovendoor
can be opened.
3. Correct the condition which caused the smoking.
4. Restart the self-clean cycle once all conditions have
been corrected.
Failure Modes
All failure modes give a visual and audible alarm. When
displayshowsF10(temperaturerunaway),F30(oven
sensorcircuitfault)orF90(motordoorlockfault),the
electronic oven control has detected a fault condition.
Note that code and push the CLEAR OFF pad to clean
the display and stop the beeping. Reprogram the oven.
Iffaultrecurs,pushCLEAROFFpad,disconnectthe
appliance to prevent damage and contact an authorized
servicer.
 previous next