Filter
Top Products
CAUTION
Drawer is heavy. Use caution when lifting.
12
DOOR REMOVAL INSTRUCTIONS
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides (two screws on each side).
3 Lift drawer up and out to remove.
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer
onto slide brackets ensuring pins on each
side are fully inserted into slots on each side.
6 Tighten four drawer screws.
7 Recheck gasket seal.
8 Installthetoegrillebyttingintoplace.
Push
Against
Freezer
Drawer
Grab Drawer
At Center
From Both
Sides Then
Pull Drawer
Out
A B
Assembly
Drawer Slides
Pin
Slot
Cabinet
Drawer
Fully Extend
Install Screws
(2) Each Side
3 Check gasket seal around top, bottom,
and sides of freezer drawer.
4 If gasket is not sealed, open drawer and
slightly loosen four drawer screws (two on
each side) to allow drawer to rotate.
5 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
NOTE
Do not remove center screw from freezer
drawer. This is a factory adjustment.
2 Reinstall four drawer screws (two per
side), tighten down, and close drawer (C).