Frigidaire DGHF2360PF Refrigerator User Manual


  Open as PDF
of 40
 
30
CHANGING THE FILTER
Locating the Filters
Yourrefrigeratorisequippedwithwaterltering
system.Thewaterltersystemltersall
dispensed drinking water, as well as the water
used to produce ice.
Water Filter
Thewaterlterislocatedatthetoprightside
of the fresh food compartment.
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisit
our online store at www.frigidaire.com/store,
by calling toll-free at 877-808-4195, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
orderextralterswhenyourstinstallyour
refrigerator,andthatyoureplaceyourltersat
least once every six months.
Hereistheproductnumbertorequestwhen
ordering:
PureSource Ultra
TM
Water Filter
Part #ULTRAWF
Replacing the Water Filter
Ingeneral,youshouldchangethewaterlter
every six months to ensure the highest possible
waterquality.Water Filter Status on the user
interfacepromptsyoutoreplacethelterafter
a standard amount of water (200 gallons/757
liters for PureSource Ultra
TM
)
hasowed
through the system.
If your refrigerator has not been used for a period
of time (during moving for example), change the
lterbeforereinstallingtherefrigerator.
Filter Cartridge
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system. Systems
certiedforcystreductionmaybeusedon
disinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• Operating Temp: Min. 33° F, Max. 100° F
• Maximum Rated Pressure - 100 pounds per
squareinch
• Recommended Minimum Operating
Pressure:30poundspersquareinch
To replace your PureSource Ultra
TM
water
lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
small amounts of water released during the
lterreplacement.
1 Turn Off the ice maker power switch.
2 Removethelterbypushingontheend/face
ofthelter.
3 Slidetheoldwaterltercartridgestraightout
of the housing and discard it.
4 Unpackagethenewltercartridge.Using
the alignment guide, slide it gently into the
lterhousinguntilitstopsagainstthesnap-in
connector at the back of the housing.
5 Pushrmlyuntilthecartridgesnapsinto
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at the
lterhousing.Anyspurtsandsputtersthat
occur as the system purges air out of the
dispenser system are normal.
7 Afterllingoneglassofwater,continue
ushingthesystemforaboutfourminutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red
to Green, the status has been reset.
The PureSource Ultra
TM
ice and
waterltersystemistestedand
certiedtoNSF/ANSIStandards42and
53forthereductionofclaimsspecied
on the performance data sheet.
More about your Advanced
Water Filter
NOTE
Whenorderingyourreplacementlter,
pleasereorderthesameltertypethatis
currently in your refrigerator.
 previous next