Filter
Top Products
41
Troubleshooting
Before You Call For Service…
“SENSOR ERROR” appears in
the display?
When using a Sensor feature, the door was
opened before steam could be detected. Do
not open door until steam is sensed and time
is shown counting down on display.
Steam was not detected in maximum amount
of time. Use Cook Time to heat for more
time.
You hear an unusual, low-
tone beep?
You have tried to start the Reminder without
a valid time of day. Start over and enter a valid
time of day.
You have tried to start the Auto Nite Light
without a valid time of day entered for the on-
time and off-time. Start over and enter a valid
time of day.
You have tried to turn the turntable on when
the probe is in use. The turntable will not
operate when the probe is in use.
You have tried to change the power level
when it is not allowed. Many of the oven’s
features are preset and cannot be changed.
Things That Are Normal
• Steam or vapor escaping from around the
door.
• Light reflection around door or outer
case.
• Dimming oven light and change in the
blower sound at power levels other than
high.
• Dull thumping sound while oven is
operating.
• TV-radio interference might be noticed
while using the microwave. Similar to the
interference caused by other small
appliances, it does not indicate a problem
with the microwave. Plug the microwave
into a different electrical circuit, move the
radio or TV as far away from the
microwave as possible, or check the
position and signal of the TV/radio
antenna.
49-400651v03 9/13/00 3:39 PM Page 41