Filter
Top Products
HEATED PASS THROUGH
INSTALLATION, OPERATION, SERVICE, AND PARTS
1
1. Parts Ordering and Service Information
Parts orders may be placed directly with your local Frymaster Factory Authorized Service Center
(FASC)/Distributor. A list of Frymaster FASC/ Distributors was included with the unit when
shipped from the factory. Your nearest FASC can also be found on Frymaster’s Web site,
Frymaster.com. or you can contact the Frymaster Service Department at 1-800-24-FRYER or 1-318-
865-1711.
To speed up your order, the following information is required:
Model Number _________________________
Serial Number _________________________
Voltage_______________________________
Item Part Number_______________________
Quantity Needed _______________________
Service may be obtained by contacting your local Frymaster Authorized Service Center/Distributor.
Service information may be obtained by calling the Frymaster Service Department. The following
information will be needed in order to assist you quickly and efficiently:
Model Number _________________________
Serial Number _________________________
Nature of theProblem_____________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
Also include any other information which may be helpful in solving your service problem.
RETAIN AND STORE THIS MANUAL IN THE EQUIPMENT MANUAL FOR FUTURE USE.
2. General
The Heated Pass Through or HPT is designed to hold assembled sandwiches. By circulating heated
air evenly across the open staging area, the unit keeps sandwiches hot without drying or cooking.
3. Installation/Set Up
Upon arrival, inspect the HPT for concealed damage. Immediately report any damage to the
delivering freight company. Claims must be filed within 15 days after receipt of the unit.
Make sure that the unit is placed on an even surface and that the area surrounding the HPT is free of
clutter that would interfere with airflow.
Install the Filter Screen
The filter screen is designed to prevent debris from
entering the cowl assembly and clogging the
blower. Slip the part over the vent opening on the
ON/OFF switch side of the unit. The filter screen
snaps into position. If it is equipped with an
optional holding screw, tighten the screw to pull the
filter screen snug into position.
The filter screen snaps into place on the air-intake
tower.