Filter
Top Products
SUPER MARATHON SERIES GAS FRYERS
CHAPTER 3: INSTALLATION INSTRUCTIONS
3-15
3.8 Gas Conversion Components
Use the following components to convert from natural gas to propane and vice-versa. See Section
3.6 for orifice quantities required for conversion.
Natural Gas to Propane Components Propane To Natural Gas Components
REF DESCRIPTION REF DESCRIPTION
810-2400 Pilot orifice (16LP) 810-0811 Pilot orifice (26N)
Burner orifice*
(See Tables on Page 3-10 – 3-11)
Burner orifice*
(See Table on Page 3-10 – 3-11)
New Rating
Label
Contact factor
y
at time of
conversion. PN 802-2144
New Rating
Label
Contact factor
y
at time of
conversion. PN 802-2144
* Burner orifices listed on page 3-10 – 3-11 are for fryers operating at altitudes o
f
2000 feet (610 meters) or less. For altitudes greater than 2000 feet (610 meters),
contact the factory for the correct orifice size.
3.9 Electrical Connections
Fryers without built-in filtration do not require electrical connection. Fryer systems with built-in
filtration when installed must be electrically grounded in accordance with local codes, or in the
absence of local codes, with the appropriate national standards.
WARNING
Fryers with built-in filtration systems are equipped with a three-prong (grounding)
plug for protection against shock hazard. It should be plugged directly into a
properly grounded, three-prong receptacle. DO NOT CUT, REMOVE, OR
OTHERWISE BYPASS THE GROUNDING PRONG ON THIS PLUG.
For fryers with built-in filtration systems: The rating plate and wiring diagram are located on the
inside front door panel. Built-in filtration systems are equipped with 120VAC single-phase 60-hertz
system (Domestic), or 230VAC single-phase 50-hertz system (International/CE). Do not cut or
remove the ground prong from the power cord plug.
DANGER
This appliance requires electrical power (built-in filtration systems only) for
operation. Place the gas control valve in the OFF position in case of a prolonged
power outage. Do not attempt to operate this appliance during a power outage.