Filter
Top Products
30
– Press the – or + key to change the duration of the
pyrolysis. You can choose between the following
times: 02:00, 02:30 and 3:00.
– Press the (Confirm) key to start pyrolysis. An
audible signal is sounded.
– For your safety, the oven door is locked
immediately. The locking and unlocking process
takes about 30 seconds. The (door lock)
symbol lights up during this time. The oven
lighting goes off. On the display, the (door
lock), (cooking time) and (pyrolysis)
symbols light up.
Do not try to open the oven door during the self-
cleaning process.
Note: during the pyrolysis process, it is not
possible to query the temperature value nor the
time.
End of pyrolysis:
After the pyrolysis process has ended, an audible
signal sounds and the (cooking time) symbol
flashes. Press any key and turn the “Temperature"
control knob to the 0 position and the “Mode" knob
to a position other than Pyrolysis.
Please note that, for safety reasons, the door will not
be unlocked until until the oven has cooled down to
150 °C. The door lock symbol goes off.
Wait until the oven has cooled down; then, you can
remove any pyrolysis residues (e.g. ash) from the
oven compartment.
Ending the pyrolysis process before expiry of
the entered time:
– Turn the “Temperature" control knob to the 0
position and the “Mode" control knob to a position
other than Pyrolysis.
– Pay attention to the fact that the door is not
unlocked until at a temperature of 150 °C or less.
Tip: wait until the appliance indicates that the
pyrolysis process has ended. This ensures that you
will achieve an optimum cleaning result.
Starting pyrolysis at a later time:
– Enter the required switch-off time (see
Chapter 3).
– Turn the control knobs to the pyrolysis setting as
described above.
Note: you can query the current pyrolysis time by
pressing the (Timer) key. You can increase the
length of the pyrolytic cleaning process during
operation. Press the + key to increase the value
by 30 minutes in each case. Confirm the value by
pressing the (confirmation) key.
In this mode of operation (auto pyrolysis), even
stubborn soiling is burnt away at temperatures
around 485°C.
After the pyrolytic cleaning process, you can
remove the ash easily from the oven using a moist
cloth.