Filter
Top Products
20
1. Attaching the toe kick panel
Note:
Risk of damage to the appliance. Do not cover ventilation
openings in the base panel.
Nominal dimensions to be observed:
1. Where necessary, cut the base strip to the required
length.
2. Place base panel on the appliance (do not screw
on).
3. Take the protective film off from the adhesive pads
on the Velcro strip.
4. Put the base strip onto the base panel and push
firmly.
5. Base strip can be screwed to the base panel from
behind. There are holes in the base panel for this
purpose.
2. Aligning the base panel
1. Place base panel on the appliance (do not screw
on).
2. Measure the difference in depth A between the base
panel and the base strip of the adjacent lower
cabinets.
3. Remove the base panel again.
4. Adjust the brackets (a) to the dimensions A and
tighten.
5. Fasten the base panel.