Filter
Top Products
35
Connecting the water to the appliance
Note:
When bending the water line, do not kink it, otherwise
there is a risk of leaks and water damage.
1. Remove the cap from the appliance connection.
2. Bend the water line according to the location of the
connection on the appliance.
3. Push the union nut and seal onto the water line.
4. Push the end of the water line into the appliance
connection and screw on the union nut.
5. Using the open-ended wrench, tighten the union nut.
Do not overturn!
6. Push back the water line into the guard tube as far
as possible.
7. Open the shut-off valve and main water tap.
8. Check the connection on the shut-off valve and on
the appliance for leaks.
9. Close the shut-off valve.
Adjusting the door opening angle
Depending on the installation situation, it may be
necessary to adjust the door opening angle. A door
opening angle of 115° has been set at the factory.
To adjust the door opening angle to 90°:
1. Open door to 90°.
Insert the banking pin through the boreholes which are
now vertically aligned and drive in with a hammer.