Stovax Electric Stove Range Range User Manual


  Open as PDF
of 15
 
1. FITTING STOVES
Most stoves are heavy and do not require 'anchoring' to the
hearth or floor but in certain circumstances the appliance can
become unstable e.g. when leaning on the stove or similar. If
this is likely, secure the appliance to the hearth or floor with
suitably strong fixings.
1.1 FOR MARLBOROUGH, MANHATTAN, STOCKTON,
STOCKTON 5:
• Position the stove ensuring all appropriate clearances are
observed
Using a pencil:
• Markthepositionoftheholesinthefixingbrackets
attached to the inside of the rear legs
• Removethestoveanddrillholesusinganappropriate
drill
• Pushrawlplugsintotheholesandinsertthewood
screws until the head is approximately 3mm proud of the
hearth
• Placethestoveinpositionoverthebracketssothatthe
screw heads locate in the large part of the slot
• Pushthestovebacksothatthescrewheadsengagefully
into the narrow part of the slot
• Tightenthescrewsifdesired
1.2 FOR THE F40 AVANTI
For Midi and Highline versions of the F40, you must remove
the base panel of the carcass, Diagram 1
1
AR1471
Bolting down the fire
It is now possible to access the two tabs for bolting the fire
down (if required):
• Positionthestove,makingsureallappropriateclearances
are observed
Using a pencil:
• Markthepositionoftheholesinthefixingbracket.
Diagram 2
13
INSTALLATION INSTRUCTIONS
2
AR1456
• Removethestoveanddrilltheholesusingamasonry
drill
• Insertrawlplugs
• Repositionthestoveandlevelitusingthethreelevelling
bolts in the base
• Screwthefiredown
• Replacethedecorativebasecoverpanel,iffitted
• Reassembleinreverseorder
2. FAULT FINDING
2.1 No illumination of the loose fuels, (or uneven lighting)
-first check if the heater is working. If YES, you probably need
newbulbs.NewbulbsareavailablefromGazcodealersand
most electrical shops.
IfNO,firstchangethe13ampfuseforonewhichyouknow
works. If the fire still does not work, check the socket by
plugging in an appliance you know is working. If this too fails
to operate, call in a competent electrician to check the
socket.
2.2 Illumination but no heat - the safety cut-out has operated to
protect against overheating. See note in Operating
Instructions above but, in particular; ensure the air inlet and
outlet grilles are free of dust or any other obstruction.
2.3 Remote control fails to work - First check that the batteries
are new and correctly fitted. Ensure that the handset is
pointing at the window of the fire.
Disposal
This product must not be disposed together with domestic waste.
This product has to be disposed at an authorised place for
recycling of electrical and electronic appliances.
By collecting and recycling waste, you help save natural resources
and make sure the product is disposed in an environmental
friendly and healthy way.
 previous next