Filter
Top Products
7.3 Lie the door on a soft flat surface, to protect the glass and
the paintwork
7.4 Remove the old door rope seal and scrape old glue from
t
he locating groove. Clean the locating groove with a clean
dry cloth to remove all old dust and debris.
7
.5 Using a 2.5mm A/F hexagon key, remove the exposed
fixing screws in the rope seal locating groove, then remove
the trim/frame. The old glass can then be lifted clear of the
d
oor. (Note how the edge sealing tape is fixed.) Remember
to dispose of the old glass safely.
7.6 Clean, and re-paint, the rear of the door if required. Clean
the screws with light oil or WD40®, this will aid future
removal.
7.7 Fit the edge sealing tape to the new glass, and place the
glass into position in the door. Place the door trim/frame
back in to position and re-fix with the clean fixing screws.
7.8 Squeeze a generous bead of fresh Thermic Seal glue into
the rope locating groove.
Do not glue over the screw
heads.
Press the new door sealing rope into the locating
groove, placing the joint in the middle of the lower edge of
the door.
7.9 Refit the door on to the appliance and close the door to
apply pressure to new rope. Leave the appliance closed for
at least 12 hours before lighting the appliance and us at a
low output for approximately one day.
7.10 Fit only Stovax Ceramic Glass, which is suitable to use in
high temperature applications.
7.11 Using the appliance with a damaged door glass could cause
dangerous fumes to enter the room, or the stove to overfire,
resulting in damage.
8.1 To maintain the safe use of your Riva stove you may need
to replace a damaged or worn door sealing rope. To
complete this operation, use this method.
8.2 To remove the door first remove the hinge pin. Unscrewing
the hinge pin from the body of the Riva and pulling the pin
does this. Support the weight of the door before removing
the pin. The door should be kept in the closed position
when the pin is removed. Release the door catch to lift the
door clear of the hinge blocks.
8.2 Remove the old rope and scrape old glue from the locating
groove. Clean the locating groove with a clean dry cloth to
remove all old dust and debris.
15
MAINTENANCE and SERVICING
7.1 To maintain the safe use of your stove you may need to
replace a damaged door glass. To complete this operation,
use this method.
7.2a
RIVA AVANTI - To remove the door first remove the hinge
pin. Unscrewing the hinge pin from the body of the Riva
and pulling the pin out from the hinge block does this.
Support the weight of the door before removing the pin.
The door should be kept in the closed position when the
pin is removed. Release the door catch to lift to door clear
of the hinge blocks.
7.2b
RIVA CUBE - Remove the door from the Riva stove, by
opeing the door by approximately 25mm and lifting the
door free of the hinge blocks on the left of the door.
8. FITTING A NEW DOOR SEAL
PR7181
PR7102
7. FITTING A NEW DOOR GLASS
D
oor Rope Seal
F
ixing Screw
Trim/Frame
G
lass Edge Seal Tape
Glass
T
rim/Frame
D
oor
Door Rope Seal
Fixing Screw
Trim/Frame
Glass Edge Seal Tape
Glass
Door
RIVA AVANTI
RIVA CUBE