Light Bulb Replacement
Cmtip
L@t
RephcementOven Li@t Replacement
To replace
your oven light, first
disconnect power at main fuse
or circuit breaker or pull plug.
Remove the top grill by taking off
3 screws which hold it in place.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Remove bulb and
re~lace with
30-watt
incandesce~t bulb (Part No.
WB02X4235) available from your
GE supplier. Secure light housing
with screw.
,
T
REMOVE
SCREti
To replace
cooktop light, first
disconnect power at main fuse or
circuit breaker
panel
or pull plug.
Remove screw on right side of light
compartment cover and lower
-
cover until it stops.
Be sure bulbs to be replaced are
cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs (Part No.
WB02X4253) available from your
GE supplier. High intensity 40-watt
bulbs
(40SlW/1)
which are
avtiable
in supermarkets and hardware stores
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
29
2rounding
~mtructiom
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electrical
current. This appliance is equipped
with a power cord having a
grounding wire with a grounding
plug. The plug must be plugged
into an outlet that is properly
installed and grounded. (Fig. 1)
WARNING–Improper
use of the grounding plug can result
in a risk of electric shock.
INSURE PROPER
GROUND EXISTS
, Fig. 1
BEFORE USE
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circumstance
cut or remove the third
@round)
prong from the power cord.
Do not use an adapter plug with
this appliance.
Do not use an extension cord with
this appliance.
——