8
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
About the dishwasher control panel.
Control Settings
Status Indicator Lights
The Status display tells you what’s happening while the dishwasher is in operation and may flash,
indicating a malfunction (see page 8). The lights will come ON indicating the sequence
of operation the dishwasher is in.
SANITIZED Displayed when cycle has met sanitization conditions. Light remains ON until
(on some door is opened.
models)
CLEAN Displayed when a wash cycle is complete. The light stays ON as a reminder that
(on some the dishes are clean until the door is opened or until another cycle is selected.
models)
Cycles
The light above the selected pad will be ON to indicate which cycle has been selected.
SANI WASH 7.3 gal., 97 min.
(on some
This cycle raises the water temperature in the final rinse to sanitize your dishware.
models)
The cycle length will vary depending on the temperature of your inlet water.
NOTE: The SANI WASH cycle is monitored for sanitization requirements. If the
cycle is interrupted during or after the main wash portion or if the incoming water
temperature is so low that adequate water heating cannot be achieved, the
sanitizing conditions may not be met. In these cases, the Sanitized light will not
illuminate at the end of the cycle.
NOTE: NSF certified residential dishwashers are not intended for licensed food
establishments.
POTS & PANS 8.5 gal., 89 min.
or HEAVY This cycle is meant for heavily soiled dishes or cookware with dried-on or baked-
WASH on soils. Everyday dishes are safe to be used in this cycle.
NORMAL WASH 5.6 gal., 56 min.
This cycle is for medium/heavily soiled dishes and glassware.
LIGHT WASH 6.1 gal., 36 min.
(on some This cycle is for everyday dishes and glassware.
models)
CHINA CRYSTAL 6.1 gal., 39 min.
(on some This cycle is for lightly soiled china and crystal.
models)
RINSE ONLY 1.2 gal., 6 min.
For rinsing partial loads that will be washed later. Do not use detergent with
this cycle.
NOTE: Only the SANI WASH cycle has been designed to meet the requirements of Section 6,
NSF 184 for soil removal and sanitization efficacy
.
1
1
3
4
2
2
Choose the dishwasher control panel that corresponds to the features on your dishwasher.