Installation Instructions
TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket by removing the
three Torx
®
screws.
NOTE: Keep these screws with the hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
On some models, you will need to remove the color-
matched caps from the screw heads before you can
remove the screws. Use the edge of a thin flat blade to
gently pry the caps off the screw heads. (A putty knife
works well for this.) Cover the blade with tape to
prevent scratching the paint.
Remove the three Torx
®
screws from the center left
side of the cabinet. Screw them into the holes on
the right side.
Place the center hinge bracket over the holes at
the center left side of the cabinet. Insert and
tighten the three long screws.
Replace the caps by snapping them over the screws
with your finger.
5
TRANSFER DOOR STOPS
On each door, move the metal door stop from the
right to the left.
Move any screws from the left to the right.
6
21
Door Stop
Door Stop
Left Side
Right Side
TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remove it by grasping it
about 6″ from each end and pulling its bottom edge
toward you.
Using a Torx
®
driver, move the bottom hinge bracket
and plastic washer from the right side to the left side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom of the door.
4
Plastic Washer
Hinge Bracket
For models with a base grille, before replacing the
base grille, remove the grille cap by removing the
screw. Screw the cap to the opposite side.
Replace the base grille by inserting the tops of the
metal clips into the oval vents, making sure one of the
plastic tabs on the back of the grille goes into each of
the oven vents. Then push the bottom of the grille
forward until it snaps into place.
Screw Cap