Filter
Top Products
16
Consumer Support Troubleshooting Tips
Operating Instructions
Safety InstructionsInstallation Instructions
Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker
The icemaker will have to be connected to a cold
water line.
You can order a water supply kit (containing copper
tubing, shutoff valve, fittings and instructions) by
visiting our Website at
www.GEAppliances.com
or
from Parts and Accessories, 800-626-2002.
Refrigerator Location
Do not install the refrigerator where the
temperature will go below 60°F (16°C)
because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it
fully loaded.
Clearances
Allow the following clearances for ease of
installation, proper air circulation and
plumbing and electrical connections:
21′ and 23′ 25′, 27′, and 29′
Sides 1/8″ (4 mm) 1/8″ (4 mm)
Top 1″ (25 mm) 1″ (25 mm)
Back 1/2″ (13 mm) 1″ (25 mm)
If the refrigerator is against a wall on either side,
allow the following door clearances:
21′, 23′, 25′, and 27′ models with flat doors: 2
5
⁄8″ (67 mm)
25′ and 27′ models with bowed doors: 3
11
⁄16″(94 mm)
29′ models with flat doors: 4
5
⁄16″(110 mm)
29′ models with bowed doors: 5
3
⁄8″ (70 mm)
Rollers
The rollers have 3 purposes:
Rollers adjust so the door closes easily when
opened about halfway. [Raise the front about
5/8″(15 mm) from the floor.]
Rollers adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
Rollers allow you to move the refrigerator away
from the wall for cleaning.
Final leveling adjustments should be made after the
refrigerator has been installed.
To adjust the rollers on 25
′
, 27
′
, and 29
′
models:
Turn the roller adjusting screws
clockwise to raise
the refrigerator,
counterclockwise to lower
it. Use a
3/8″ hex socket or wrench, or an adjustable wrench.
To adjust the rollers on 21
′
and 23
′
models:
Remove the base grille by opening the doors,
removing the screws at each end, and pulling
it straight out.
Turn the front roller adjusting screws
clockwise to
raise
the refrigerator,
counterclockwise to lower
it.
Use a 3/8″ hex socket or wrench, or an adjustable
wrench.
These models also have rear adjustable rollers so
you can align the refrigerator with your kitchen
cabinets. Use a long-handled 5/16″ socket wrench
to turn the screws for the rear rollers—
clockwise to
raise
the refrigerator,
counterclockwise to lower
it.
3
2
1
Roller adjusting screws
Roller adjusting screw