Filter
Top Products
10
DETERMINING REAR MOUNTING SCREW LOCATIONS
Use a level to check that the template is positioned
accurately.
Locate and mark at least one stud on the left or right
side of the centerline. It is important to use at least one
wood screw mounted firmly in a stud to support the
weight of the microwave.
Mark three additional, evenly spaced locations for the
supplied toggle bolts.
Drill holes in the marked locations. If there is a stud,
drill a
3
⁄16″ hole for wood screws. For holes that don’t
line up with a stud, drill a
5
⁄8″ hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
1
2
3
D.
Installation Instructions
CAUTION: Wear gloves
to avoid cutting fingers
on sharp edges.
NOTE: The Rear Wall Template serves
to position the bottom mounting plate and
to locate the horizontal exhaust outlet.
C
L