Filter
Top Products
Li@t Bulb Replacement
Cooktop
Light/Night Light
Oven Light
REMOVE SCREW
To replace
combination cooktop
light/night light, first disconnect
wwer
at main fuse or circuit
To replace
your oven light, first
disconnect power at main fuse or
circuit breaker or pull plug.
breaker panel or pull plug.
Remove the top
grill
by taking off
Remove screw on right side of light
3 screws which hold it in place.
compartment cover and lower cover
until it stops.
Be sure bulbs to be replaced are
cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs (Part No.
WB02X4253) available from vour
Next, remove the single screw
located above door near center of
oven that secures light housing.
Remove bulb and replace with
a 30-watt GE bulb (Part No.
WB2X4235) available from your
GE supplier. Secure light housing
GE supplier. ‘High intensity 40-watt
with screw.
bulbs
(Part
No.
40SllN/1)
which
are available in supermarkets and
hardware stores may also be used
for replacements. Raise light
compartment cover and replace
screw. Connect electrical power to
microwave oven.
Grounding
Imtructiom
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
WARNING-Im~roper
use of the grounding plug
~an’result
in a risk of electric shock.
INSURE PROPER
GROUNO
EXISTS
, Fig. 1
BEFORE USE
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under
any
circmtance
cut or remove the third
@round)
prong from the power cord.
Do not use an adapter plug
with this appliance.
Do not use an extension cord
with this appliance.
30