Filter
Top Products
31
Light Bulb Replacement Grounding Instructions The Exhaust Feature
GROUNDING INSTRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
grounded. (Fig. 1)
WARNING—Improper
use of the grounding plug can
result in a risk of electric shock.
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard 2-prong wall
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded 3-prong wall
receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
Do not use an extension cord
with this appliance.
Reusable Grease Filters
The grease filters should be cleaned at least once a month. Never
operate the microwave without the filters in place. In situations where
flaming might occur on surfaces below hood, filters will stop the entry
of flames into the unit.
PREFERRED
METHOD
Ensure proper ground
Fig. 1 exists before use
THE EXHAUST FEATURE
The exhaust hood feature on your microwave oven is equipped with two
metal filters which collect grease. When the fan is operated, air is drawn
up through the filters and is then discharged through the provided venting
to the outside.
METAL
FILTER
COOKTOP
LIGHT
METAL
FILTER
To Remove Grease Filter To Clean and Replace Grease Filter
To remove grease filter,
grasp the “finger hold”
on the filter and slide to
the rear. Then pull filter
downward and to the
front. The filter will
drop out.
To clean grease filter, soak it and then agitate filter
in solution of hot water and detergent. Don’t use
ammonia or ammonia products because they will
darken the metal. Light brushing can be used to
remove embedded dirt.
Rinse, shake and remove moisture before replacing.
To replace grease filter, slide the filter in the frame
slot on the back of the opening.
Pull filter upward and to the front to lock into place.
(continued next page)