Open as PDF
Window Installation Instructions
INSTALL THE CASE
IN THE WINDOW
Use a wood block (obtained locally) between
the leveling bolts and the wall if the wall is
weak or if the weight of the air conditioner
falls between the studs in the wall.
Adjust the leveling bolts and nuts against the
outside wall so that the case has a slight tilt
to the outside. Tighten nuts with an adjustable
wrench. Use a level; no more than a 1/2 bubble
will be the correct case slant to the outside.
Extend the left and right accordion panels
to the vertical window sashes. Drill pilot
holes and attach the top and bottom corners
with 4 type D screws.
Top mounting rail
INSTALL SUPPORT BRACKETS AND
FOAM TOP WINDOW GASKET
Drill pilot holes and
attach the support
brackets with two type
D screws, one on each
Cut the foam top window gasket to the
Stuff the foam
glass and the
prevent air and
getting into the room.
NOTE: If the gasket supplied does not fit
your window, obtain appropriate material
locally to provide a proper installation seal.
To prevent broken glass
or damage to windows,
on vinyl or other
windows, attach the
support bracket to the
window side jam.