GE C2S980 Convection Oven User Manual


 
Burner Heads (on some models)
Place burner heads over the electrodes
on the cooktop, in the correct locations
according to their size. There is one small, one
medium, one extra large and one dual flame
extra large burner head.
Oval (Center) Burner Head/Cap Assembly
Place the oval (center) head/cap assembly
over the electrode on the cooktop.
Caps
Place the matching size caps onto the burner
bases or heads.
Make sure that the heads and caps are
replaced in the correct locations.
Grates
Place the left, right and center grates on the
cooktop. These grates are position specific.
The undersides of the left and right grates are
marked “OUTSIDE.” Place the middle grate with
its bowed front toward the front of the range.
CAUTION: Do not operate the burner
without all burner parts in place.
50
Installation of the range.
Seal the Openings
Seal any openings in the wall behind the range
and in the floor under the range when hookups
are completed.
Assemble Surface Burners
Operating Instructions
Safety Instructions
Installation
Instructions
Troubleshooting TipsConsumer Support
Electrode
Slot
Front of range
Oval head and
cap assembly
Medium cap
Front of range
Extra large cap
Small cap
Dual flame extra
large cap
Make sure the slot
in the burner head
is positioned over
the electrode.
Outside grate
Outside grate
Center grate
Burner cap
Burner
head
Burner base
Electrode
Burner cap
Burner
head
Burner
base
Electrode
Stability
chamber
Make sure the slot
in the burner head
is positioned over
the electrode.
Make sure the hole in the burner head
assembly is positioned over the electrode
and that the burner head is fully inserted
inside the burner base. A small gap
between the base and head is normal.
Front left, back right and back left burners
Front right burner
Medium head
Front of range
Extra large
head
Small head
Dual flame
extra large head