Changing the Speed of the Increase or Decrease Pads
As you use the INCREASE or DECREASE pads
when setting a time or temperature, you may
notice the display changes slowly. This special
feature allows you to change the speed.
To set the speed you prefer, follow the
steps below.
Press the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Press the + pad. The display will
show you a set speed between
1 and 5.
Press the + pad to increase the speed
up to the number 5.
Press the – pad to decrease the
speed down to the number 1.
Press START to activate the setting
and leave the control set in this
special features mode.
+
17
Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support
GEAppliances.com
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds until
the CLEAR/OFF pad is pressed. This continual
6 second beep may be canceled.
To cancel the 6 second beep:
Press the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Press the BROIL HI/LO pad. The
display shows CON BEEP (continual
beep). Press the BROIL HI/LO pad
again. The display shows BEEP.
(This cancels the one beep every
6 seconds.)
Press the START pad.
+
12 Hour, 24 Hour or Clock Black-Out
Your control is set to use a 12 hour clock.
If you would prefer to have a 24 hour
military time clock or black-out the clock
display, follow the steps below.
Press the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Press the TIMER/CLOCK pad once.
The display will show 12 hr. If this is
the choice you want, press the
START pad.
Press the TIMER/CLOCK pad again to
change to the 24 hour military time
clock. The display will show 24 hr. If this is
the choice you want, press the START pad.
Press the TIMER/CLOCK pad again to
black-out the clock display. The display
will show OFF. If this is the choice you
want, press the START pad.
NOTE: If the clock is in the black-out mode, you
will not be able to use the Delay Start function.
+
Cook and Hold
Your new control has a cook and hold feature that
keeps cooked foods warm for up to 3 hours after
the cooking function is finished.
To activate this feature, follow the steps
below.
Press the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.
Press the COOKING TIME pad.
The display will show Hld OFF.
Press the COOKING TIME pad again
to activate the feature. The display
will show Hld ON.
Press the START pad to activate
the cook and hold feature and
leave the control set in this special
features mode.
+