Filter
Top Products
21
How to Delay the Start of Cleaning
Make sure the clock shows the correct
time of day.
Press the SELF CLEAN pad.
Using the + or – pads, enter the
desired clean time.
Press the DELAY START pad. The
earliest start time you can set will
appear in the display.
Using the + or – pads, enter the
time of day you want the clean cycle
to start.
Press the START pad.
The door locks automatically. The
display will show the start time. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and the LOCKED door
light goes off.
When the LOCKED door light is off,
open the door.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a soap-
filled steel wool pad and rinse thoroughly with
a vinegar and water mixture.
These deposits are usually a salt
residue that cannot be removed by
the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
Apply a small amount of vegetable oil to
a paper towel and wipe the edges of the
oven shelves with the paper towel. Do not
spray with Pam
®
or other lubricant sprays.
■ You cannot set the oven for cooking
until the oven is cool enough for the
door to be unlatched.
■ While the oven is self-cleaning, you
can press the TIMER/CLOCK pad to
display the time of day. To return
to the clean countdown, press the
COOKING TIME pad.
GEAppliances.com
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support