Filter
Top Products
Safety Instructions
Operating Instructions
Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips Consumer Support
GEAppliances.com
Problem Possible Causes What To Do
Storage drawer Power cord may be obstructing • Reposition the drawer and power cord. See the
won’t close drawer in the lower back of Storage Drawer Removal instructions in the Care and
the range. cleaning of your range section.
Rear drawer support is • Reposition the drawer. See the Storage Drawer
on top of the guide rail. Removal instructions in the Care and cleaning of
your range section.
Oven will not self-clean The oven temperature is • Allow the oven to cool to room temperature and
too high to set a self-clean reset the controls.
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
“Crackling” or This is the sound of the • This is normal.
“popping” sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. • Press the CLEAR/OFF pad. Open the windows to
during a clean cycle rid the room of smoke. Wait until the LOCKED door
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not Oven too hot. • Allow the oven to cool below locking temperature.
open after a
clean cycle
Oven not clean after Oven controls not properly set. • See the Using the self-cleaning oven section.
a clean cycle
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCK DOOR” flashes The self-clean cycle has been • Close the oven door.
in the display selected but the door is not
closed.
LOCKED DOOR light The oven door is locked • Press the CLEAR/OFF pad. Allow the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
“F— and a number You have a function • Press the CLEAR/OFF pad. Put the oven back into
or letter” flash error code. operation.
in the display
If the function code repeats. • Disconnect all power to the range for at least
30 seconds and then reconnect power. If the function
error code repeats, call for service.
29