Filter
Top Products
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
32
Do not store a soiled broiler pan and
grid anywhere in the range.
Stop guide
Rail
Wire cover holder.
Do not clean the broiler pan or grid in a self-
cleaning oven.
After broiling, remove the broiler pan
from the oven. Remove the grid from
the pan. Carefully pour out the grease
from the pan into a proper container.
Wash and rinse the broiler pan and grid in hot
water with a soap-filled or plastic scouring pad.
If food has burned on, sprinkle the grid
with detergent while hot and cover with
wet paper towels or a dishcloth. Soaking
the pan will remove burned-on foods.
Both the broiler pan and grid may be cleaned with
a commercial oven cleaner.
Both the broiler pan and grid can also be
cleaned in a dishwasher.
Care and cleaning of the range.
Oven Light Replacement
CAUTION: Before replacing your oven
light bulb, disconnect the electrical power to the
range at the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
To remove the cover:
Hold a hand under the cover so it
doesn’t fall when released. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Do not remove any screws to remove
the cover.
Replace bulb with a 40-watt
appliance bulb.
To replace the cover:
Place it into groove of the light
receptacle. Pull wire forward to the
center of the cover until it snaps
into place.
Connect electrical power to the
range.
Broiler Pan and Grid
To remove the drawer:
Pull the drawer out until it stops.
Lift the front of the drawer until
the stops clear the guides.
Remove the drawer.
To replace the drawer:
Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and push
back until the stops clear the guides.
Lower the front of the drawer and
push back until it closes.
If drawer is crooked:
Remove and replace, making sure the rail
is in the guide.
If drawer won’t close:
Remove and replace, making sure the
power cord is no longer obstructing the
drawer and/or the rail is in the guide.
Storage Drawer Removal
Rear drawer support
is on top of guide rail
on the high side
Drawer does not
close completely
Power cord may be
obstructing drawer
in this area
Drawer front
panel tipped
away from
body side
Rear drawer support
is resting on top of
guide rail
Drawer front panel
tipped to one side