Filter
Top Products
23
Safety Instructions Operating Instructions Care and Cleaning
Troubleshooting Tips Consumer Support
www.GEAppliances.ca
How to Delay the Start of Cleaning
Make sure the clock shows the correct
time of day.
Latch the door.
Touch the
CLEAN
pad.
Using the
+
or
–
pads, enter the
desired clean time.
The Clean Time is normally 4 hours. You can
change the Clean Time to any time between 3
and 5 hours, depending on the amount of soil in
your oven.
Touch the
START TIME
pad. The
earliest delay start time you can set
will appear in the display.
Using the
+
or
–
pads, enter the
time of day you want the clean cycle
to start.
Touch the
START/ON
pad.
The display will show the delay start set
time. It will not be possible to unlatch the
oven door until the temperature drops
below the lock temperature and the
LOCKED
door light goes off.
When the
LOCKED
door light is off,
unlatch the door.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a soap-
filled scouring pad and rinse thoroughly with
a vinegar and water mixture.
These deposits are usually a salt
residue that cannot be removed by
the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
■ You cannot set the oven for cooking
until the oven is cool enough for the
door to be unlatched.
■ While the oven is self-cleaning, you
can press the
CLOCK
pad to display
the time of day. To return to the clean
countdown, press the
COOK TIME
pad.
■ Apply a small amount of vegetable oil
to a paper towel and wipe the edges of
the oven racks with the paper towel.
Do not spray with Pam
®
or other
lubricant sprays.
To Stop a Clean Cycle
Touch the
OFF
pad.
Wait until the oven has cooled below the
locking temperature to unlatch the door.
You will not be able to open the door
right away unless the oven has cooled
below the locking temperature.