Filter
Top Products
Your new touch pad control has additional features that you may choose to use. The following are the features and
how you may activate them.
The special feature modes can only be activated while the display is showing the time of day. They remain in the
control’s memory until the steps are repeated.
When the display shows your choice, touch the START pad. The special features will remain in memory after
a power failure.
Fahrenheit or Celsius Temperature Selection
Your oven control is set to use the Fahrenheit
temperature selections, but you may change this
to use the Celsius selections.
Touch the BAKE and BROIL HI/LO pads
at the same time for 3 seconds until
the display shows SF.
Touch the BROIL HI/LO and COOKING
TIME pads at the same time. The
display will show F (Fahrenheit).
Touch the BROIL HI/LO and COOKING
TIME pads again at the same time.
The display will show C (Celsius).
Touch the START pad.
Special features of your oven control. www.GEAppliances.com
12 Hour Shut-Off
With this feature, should you forget and leave the
oven on, the control will automatically turn off the
oven after 12 hours during baking functions or after
3 hours during a broil function.
If you wish to turn OFF this feature, follow
the steps below.
Touch the BAKE and BROIL HI/LO pads
at the same time for 3 seconds until
the display shows SF.
Touch the DELAY START pad. The
display will show 12 shdn (12 hour
shut-off). Touch the DELAY START pad
again and the display will show no shdn
(no shut-off).
Touch the START pad to activate the
no shut-off and leave the control set in
this special features mode.
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds until
the CLEAR/OFF pad is touched. This continual
6-second beep may be canceled.
To cancel the 6-second beep:
Touch the BAKE and BROIL HI/LO pads
at the same time for 3 seconds until
the display shows SF.
Touch the BROIL HI/LO pad. The
display shows CON BEEP (continual
beep) and BEEP. Touch the BROIL
HI/LO pad again. The display shows
BEEP. (This cancels the one beep
every 6 seconds.)
Touch the START pad.
Consumer SupportOperating InstructionsSafety Instructions Installation Instructions Troubleshooting Tips
Changing the Speed of the Increase or Decrease Pads
As you use the INCREASE or DECREASE pads when
setting a time or temperature, you may notice the
display changes slowly. This special feature allows
you to change the speed.
To set the speed you prefer, follow the steps
below.
Touch the BAKE and BROIL HI/LO pads
at the same time for 3 seconds until
the display shows SF.
Touch the + pad. The display will show
you a set speed between 1 and 5.
Touch the + pad to increase the speed
up to the number 5.
Touch the – pad to decrease the speed
down to the number 1.
Touch START to activate the setting
and leave the control set in this special
features mode.
17