Filter
Top Products
Troubleshooting Tips
Operating Instructions Safety InstructionsInstallation InstructionsTroubleshooting Tips
Consumer Support
46
Before you call for service…
Problem Possible Causes What To Do
“LOCK DOOR” flashes The self-clean cycle has been • Close the oven door.
in the display selected but the door is not
closed.
LOCKED DOOR light The oven door is locked •Touch the CLEAR/OFF pad. Allow the oven to cool and
is on when you want because the temperature then, on models with a door latch, unlock the door.
to cook inside the oven has not
dropped below the
locking temperature.
Oven door will not Oven is too hot. • Allow the oven to cool below locking temperature.
unlock (on models Do not lock the door with the door latch except when
with a door latch) using the self-clean feature.
“Door” appears in the Self-cleaning cycle has been • Move the latch handle all the way to the right.
display (on models selected but the latch handle
with a door latch) was not moved all the way
to the right.
Latch handle was moved to the • Move the latch handle to the right only when setting
right but a program other than the self-cleaning cycle.
self-cleaning was selected.
“F—and a number or On models with a door latch, • The latch may have been moved, even if only slightly,
letter” flash in the display if a function error code appears from the locked position. Make sure the latch is moved
during the self-cleaning cycle, to the right as far as it will go.
check the oven door latch.
You have a function error code. • Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the • See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BAKE and BROIL HI/LO pads must be touched at
display to show “SF” not touched properly. the same time and held for 3 seconds.
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFF pad, setting the clock and
resetting any cooking function.