Filter
Top Products
❑
StiL
THE OPENINGS
Seal any openings in the wall behind the range
and in the floor under the range when hookups
are completed.
❑
LIGHT
THE
PILOTS
(For Models Equipped with Standing Pilots.
If the range is an electric ignition model, the
burners are ignited by electric ignition which
eliminates the need for
stiding
pilot lights.)
The range should be installed in its permanent
position before any pilots are lit or adjusted.
Light the Surface Burner Pilots
CA~ON:
Make sure the surface burner
control knobs are in
the OFF position before
attempting to light the pilots.
1. Raise the
cooktop.
2. Light both pilots with a match.
3.
To avoid pilot outage, use caution when
closing
cooktop
after lighting pilots.
NO~:
Do not leave standing pilot lit in a newly
constructed or remodeled home or apartment
that will be unoccupied for more than a month.
Each pilot flame was adjusted at the factory to be
approximately 5/16” tall. A tinge of yellow
appearing at the upper tip is normal.
E
you find
pilot adjustment is necessary, follow instructions
at right.
Miust the Surface Burner Pilots if
Necessa~
of the manifold panel.
3. To adjust, use a
blad~type
screwdriver with
a shaft diameter of less than 3/16”. Turn pilot
adjustment screw until pilot is 5/16” high. Do
not reduce the flame to less than 5/16” or pilot
outage may occur. A pilot flame burning higher
than recommended may generate soot (carbon
black) on the bottom of your
cooktop.
Light the Oven Pilot
CA~ON:
Make sure the
O~N
CONTROL
knob is in the OFF position before attempting to
light the pilot.
1.
Remove the broiler drawer by sliding the
drawer all the way out and then lifting slightly to
remove it from it’s tracks.
2.
bcate
the pilot at the
back of the broiler
compartment. The pilot
is attached to the left
side of the oven burner.
3. Light the pilot with a
match. No adjustments ar
required for natural gas.
For
LP
gas, see How to
Convert the Range for
Use with
LP
Gas or
Natural Gas section.
(continued next page)
35