Filter
Top Products
10
INSTALLATION INSTRUCTIONS
Electrical Requirements
CAUTION: FOR PERSONAL SAFETY,
REMOVE HOUSE FUSE OR CIRCUIT
BREAKER BEFORE BEGINNING
INSTALLATION.
This appliance must be supplied with the proper
voltage and frequency and connected to an
individual, properly grounded branch circuit,
protected by a circuit breaker or time delay fuse,
as noted on the rating plate.
All wire connections must be made in
accordance with local codes and properly
insulated. Check with your local utility for
governing electrical codes and ordinances.
In the absence of local electrical codes, the
National Electrical Code, ANSI/NFPA No.
70–Latest Edition, governing electric range
installations, must be followed.
A copy of the National Electrical Code can be
obtained by writing to:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02260
If you fail to wire your counter unit in
accordance with governing codes, you
may create a hazardous condition.
CAUTION: The electrical power to the
counter unit supply line must be shut off
while line connections are being made.
Failure to do so could result in serious
injury or death.
Before You Begin
Read these instructions completely
and carefully.
IMPORTANT—Save these instructions
for local inspector’s use.
IMPORTANT—Observe all governing codes
and ordinances.
NOTE TO INSTALLER—Be sure to leave
these instructions with the Consumer.
NOTE: This appliance must be properly
grounded.
Tools You Will Need
• 1/8″ Drill bit
• Electric or hand drill
• Flat blade screwdriver
• Pencil
• Ruler or tape measure and straightedge
• Hand saw or saber saw