Filter
Top Products
If the range is removed for cleaning or any reason, make sure the chain is reattached.
Oetional
acketlocation
Backselash Anti-Tip Device
3nsomemodela
FactoryBracKet
Chain
\
Backof
range
[]
Before placing range in the counter,
notice the location of the stability
bracket which is already attached to
the back of dm range. This location
should work fbr lnOSt installations.
However, it may be lnore convenient
to hook dm stability, chain to dm unit
when the stability, bracket is attached
to tim upper set of holes in the back
of range.
Theupperlevelsetofholesisintendedforuse
witha backspleshkit.If thebackspleshisnot
beingused,makesurethatthereareno
structuralsupportsforthecountertopwhichwill
interferewiththestabilitybracketwhenlocated
in theuppersetofholes.
_] Fasten one end of the stability chain
to the floor or wall with the long
screw and washer supplied.
NOTE:If attachingtomason_youcanbuy
suitablescrewsandanchorsat hardwarestores.
Usea masonrydrill todrill therequiredholes.
LongscreW_washer__ff _
I\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
Wallplate
Makecertainthescrewisgoingintothewall
plateat thebaseof thewallor oneof thestuds
in thebaseof thewall
Whether you attach the chain to the wall
or floor, be certain that the screw is in at
least 3/4 inch thickness of wood other
than baseboard and that there are no
electrical ,dres or plumbing in the area
which the screw couM penetrate. Attach
the stability chain in a location which will
allow the chain to be in line ,_4th the
bracket side m aide as much as possible
when attached to the unit. Test to see if
the chain is securely f_tstened by ragging
on the chain.
• 4_ Tape
_] Temporarily attach the loose end of
the chain to the rear of the
countertop with the tape fi'Oln the
packaging.
_] Place the range in the counter cutout
lem_ingjust enough room between
the back of the range and the wall to
reach the stability, bracket.
Hook the loose end of the chain
onto the bracket by slipping the
nearest link of the chain into the slot
in the bracket. Make sure the chain is
pulled as tight as possible and that
there is no excess slack in the chain
after the chain is attached to the
bracket.
%
Slide file range all fl_e way back into
the counter. Once the range is
pushed back in place, there _4ll be a
small mnount of slack in the chain.
This is normal.
CAUTION:Excessiveslackin thechaincould
allowtherangetotipover.
27