Filter
Top Products
.
.iter
Self-Cleaning
You
lmay
notice some white ash in the oven. Just wipe
If the oven is not clean after one
clean
cycle,
it up with a damp cloth after the oven cools.
repeat the cycle.
If
white spots remain, remove them with a soap-filled
If
the shelves become hard to slide, wipe the shelf
steel wool
pad.
Be sure to rinse thoroughly with
supports with cooking oil.
a
vinegar and water mixture. These deposits are
NOTE: No functions can be programmed before the
usually a salt residue that cannot be removed by the
door
automatica]]y
unlocks.
clean cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1.
Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the CLEAN pad.
4. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
5. Press the STOP TIME pad.
6. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
lay
Start
is setting the oven timer to start the clean
,
cle
automatically at a later time than the present
ti_me
of day.
-
NOTE:
Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow steps to prepare the oven for cleaning.
(—~
2. Press the CLEAN pad.
u
CLEAN
3. Press the INCREASE or DECREASE
pad to enter Clean Time.
f—n
4. Press the STOP TIME
Pad.
“STOP
u
STOP
TIME” and the earliest-Stop Time you
TIME
can set will appear in the display.
The earliest Stop Time will be the Clean Time
selected
~lus
the time of dav.
For examule:
If the
Clean Time is three hours&d the time
;f
day is
6:00,
the Stop Time that appears in the display will be
9:00.
5. Press the INCREASE pad to change the Stop Time
to a later time of day if desired.
For example:
If
you set Stop Time at 11
:00,
oven will start clean
cycle at
8:00
and end at 11
:00.
The door latches
automatically.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for clean cycle
is set. The words “ON” and “LOCK” will appear in
the display when the door automatically locks.
It will not be possible to open the oven door until
the temperature drops below the lock temperature
and the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
●
During a delayed self-clean operation you can find
out when the oven is set to turn on by pressing and
holding the CLEAN pad for 3 seconds.
●
A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
(continued
next
page)
29