Filter
Top Products
OPEMT~G
T~
SELF-CLEA~G
OVEN
(continued)
How to Set Oven for Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
If the oven is too hot and you start to set a clean
cycie,
the word “OFF” will appear in the display.
Allow additional time for cooling before you
~
to
set the cycle.
1. Follow the directions in the Before a Clean Cycle
section.
n
2.
After closing the door, press the
AUTO SELF
CLEAN
AUTO SELF CLEAN pad.
A
3.
Press the INCREASE or
DECREASE pad until the
@
desired Clean Time
is
displayed.
Clean Time is normally 3 hours.
v
e
You can change the Clean Time to any
time between 2 and 4 hours, depending
on the amount of soil in your oven.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the clean
cycle is set. The words “ON” and “LOCK” will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
4.
When the LOCK light is off, open the door.
NOTE:
n
● You can find out when the clean
s;~[
cycle will be finished by pressing
the STOP TIME pad.
A
● The word “door” will be displayed, the word
“LOCK” will flash and oven control will signal
if you set the clean cycle and forget to
close
the
oven door.
● A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
To Stop a Clean Cycle
o
1.
Press the
CLEAWOFF
pad.
CLEAR
OFF
2. When the LOCK light goes off and the oven
has cooled below the locking temperature, open
the door.
20