Filter
Top Products
.,
,.
After Self-Cleaning
You
may
notice some white
ash
in the oven. Just wipe
NOTE:
it up with
a
damp
cloth
after
the oven cools.
● No functions can be programmed before the door
If white spots remain, remove them with a soap-filled
automatically unlocks.
steel wool pad. Be sure to rinse thoroughly with a
● If the shelves have become hard to slide, wipe the
vinegar
and
water mixture. These deposits are usually
shelf supports with cooking oil.
a salt residue that cannot be removed by the clean cycle.
If
the oven is not clean after one clean cycle,
repeat the
cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE pad until the desired
Stop Time appears in the display.
Delay Start is setting the oven timer to start the clean
cycle automatically ‘at a later time than the present
titne
of day.
NOTE: Before beginning, make
sure the oven clock
shows the correct time of day.
1. Follow the directions in the Before a Clean Cycle
section.
n
2. After closing the door, press the
AUTO SELF
CLEAN
AUTO SELF CLEAN pad.
A
3. Press the INCREASE or DECREASE
pad to enter the Clean Time.
@
w
e
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If
the Clean Time is three hours and the time of day
is
6:00,
the Stop Time that appears in the display
will be
9:00.
A
5. Press the INCREASE pad to change
the Stop Time to a later time of day if
@
desired. For example: If you set Stop
Time at
11:00,
oven will start clean
cycle at
8:00
and end at 11:00. The
door latches automatically.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the clean
cycle is set. The words “ON” and “LOCK” will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
❑
● During a delayed self-clean operation
AUTO SELF
CLEAN
you can find out when the oven is set
to turn on by pressing and holding the
A
AUTO SELF CLEAN pad for 3
seconds.
● A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
(c[~ntinued
next
p~lge)
n
4. Press the STOP TIME pad. “STOP
STOP
TIME” and the earliest Stop Time you
TIME
can set will appear in the display.
21