Filter
Top Products
5
Installation Instructions Customer Service
Safety Instructions Operating Instructions
To clean the hood surface, use a hot,
damp cloth with a mild detergent
suitable for painted surfaces. Use
a clean, hot, damp cloth to remove
soap. Dry with a dry, clean cloth.
Do not use steel-wool pads or other
abrasive cleaners. They will scratch
the surface. Wipe with a clean, hot,
damp cloth after using cleansers.
Painted Surfaces
(on some models)
Do not use a steel-wool pad; it will
scratch the surface.
To clean the stainless steel surface,
use a hot, damp cloth with a mild
detergent suitable for stainless steel
surfaces. Use a clean, hot, damp
cloth to remove soap. Dry with a dry,
clean cloth.
If food soil remains, try a general
kitchen cleaner, such as Fantastik
®
,
Simple Green
®
, or Formula 409
®
.
For hard-to-clean soil, use a
standard stainless steel cleaner, such
as Bon-Ami
®
or Cameo
®
.
Apply cleaner with a damp sponge.
Use a clean, hot, damp cloth to
remove cleaner. Dry with a dry, clean
cloth. Always scrub lightly in the
direction of the grain.
After cleaning, use a stainless steel
polish, such as Stainless Steel Magic
®
,
Revere Copper and Stainless Steel
Cleaner
®
, or Wenol All Purpose
Metal Polish
®
. Follow the product
instructions for cleaning the stainless
steel surface.
Stainless Steel Surfaces
(on some models)
This hood requires two bulbs (not
included), maximum 50 watts.
Purchase and install PAR20, 50 W
Maximum halogen bulbs.
When replacing a bulb, let it cool
first. Make sure that power to the
light has been turned off. Never
allow a hot bulb to come into
contact with water.
To change the light bulbs:
Grasp the bulb on the edges and
unscrew it.
Replace with the same size bulb.
CAUTION:
■
Do not touch the hood light bulbs when they
are on. They may be hot enough to cause
injury.
■
The light bulbs operate at extremely high
temperatures. If they shatter, the hot glass
could cause personal injury.
Hood Lights
If the model is not
vented to the outside,
the air will be
recirculated through
disposable charcoal
filters that help remove
smoke and odors.
The charcoal filters
should be replaced when
they are noticeably dirty
or discolored (usually
after 6 to 12 months,
depending on hood
usage).
NOTE: DO NOT rinse, or put
charcoal filters in an
automatic dishwasher.
Charcoal Filters
(on some models)
The charcoal filters
cannot be cleaned. They
must be replaced.
For 30
″
hood models, order
Kit no. WB02X10707.
For 36
″
hood models, order
Kit no. WB02X10708.
These kits can be ordered
from your GE supplier.
The charcoal filters are clipped inside
of each reusable metal grease filter.